What should you pay attention to when using the OCAMaster Bubble Remover Machine?
As far as we know, there are many bubble remover products on the market at present, for LCD screen refurbishing stores, it is very important to choose a bubble remover product with good quality and performance. Because if you unfortunately choose the one with poor quality, maybe something unexpected to happen.
In past of year, OCAMaster has sold out a lot of bubble remover machine, no any unexpected to happe, so it is our priority to choose a stable quality machine. OCAMaster have two kinds of bubble remover machine, OM-A2 and OM-A3, the difference is the size, OM-A2 for 12inches, OM-A3 for 15inches.
What should we pay attention to when we use the bubble remover machine?
First, for your safety, please read this instructions careful before using the bubble remover machine.
1. Bubble remover machine works with high pressure ( pressure recommended is about 90PSI/0.6Mpa, if you buy a air compressor which has more than 90PSI pressure, use a pressure regulator to reduce the pressure for our bubble remover please )
2. Every single time when you try to removing bubbles. Make sure you closed the door properly, because over 90% bubble remover issue caused by the door without full closing.
3. Don't open the bubble remover before the pressure drops to 0, the remaining pressure might harm you.
4. Warranty for this machine is 12 months, for your own safety, we recommend you to not use this machine over 24 months.
5. Don't let the door face to you or your staff, specially when machine start to feeding air in the bubble remover, don't let people close to the door.
6. Temperature recommended for bubble removing is less than 55 degrees, don't heat up the bubble remover over 60 degrees please.
By Ovena@OCAMaster
