An LCD separator machine is crucial to mobile LCD screen repair. It is the machine that effectively and efficiently remove the broken glass. It is very efficient in separating cracked glass from a functioning LCD on touch screen mobile phones. The two main components of a LCD separator machine is the hot plate and the clamps.
This machine, like any other separating machine, has a full proof display on its front. To use this machine to separate LCD screen; set the desired temperature of the hot plate and wait for it to heat up. When the temperatures are attained, the broken screen is placed on it. Clamping the screen using the clamps on both sides ensures that the screen is fixed. Wait for a little while, not more than a minute, then start sliding the golden wire between the LCD and the broken screen.
Not all phone are the best candidate for this kind of repair. The older phones are typically the best for this repair procedure. This is because their glass on the LCD is not fused to the LCD. Newer phones have the digitalizer, the AMOLED or the LCD glued together by the manufacturer. This makes it hard to separate them. Gluing them together helps improve the clarity of the display and no dust settles between them.
The screen is the most delicate part of a mobile phone. It is prone to damages. It can be damaged by extreme heat. You should therefor exercise caution when setting the temperature limits not to exceed the maximum requirement. LCD separator machines are more efficient than heat gun. Although it is possible to use heat guns to separate broken glass from the rest of the LCD, it takes quite some time. The chances of breaking the LCD are also high while using a heat gun than while using LCD separator machine.
After separating the LCD and the broken glass, you will require to remove the adhesive from the LCD. The best way to remove it is by use of Acetone or Gooff. You can lightly brush the excess adhesive with a soft brush. If it does not remove efficiently, you can use a plastic card to scrape it off. Do not apply too much force or make any deep cuts.
It is quite cheap to replace the broken glass only instead of replacing the whole display. If the LCD s not broken. In most cases I is only the glass that is broken. Investing in a LD separating machine is worth it.
